Cisco 678 DSL Router Setup for Static IP
 

Sonora Communications, Inc.

  • Increase font size
  • Default font size
  • Decrease font size

Cisco 678 DSL Router Setup for Static IP

E-mail Print PDF

All things in <brackets> must be changed for each different site.

Warning: this device must be disconnected from the phone line before this configuration is installed.  Once the final reboot command is given, it may be re-connected to Qwest.

The syslog logging server for Sonora Comm/Opus is 192.245.12.50.

cbos# enable
cbos# set nvram erase
cbos# write
cbos# reboot

cbos# enable
cbos# set ppp wan0-0 login <their-username>
cbos# set ppp wan0-0 pass <their-password>
cbos# set int eth0 address <their-address>
cbos# set int eth0 netmask <their-mask>
cbos# set snmp enabled
cbos# set syslog disabled
cbos# set syslog remote <syslog-server>
cbos# set prompt <customer> (8 char)
cbos# set password exec <customerpassword>
cbos# set password enable <customerpassword>
cbos# set web port 77
cbos# set web disabled
cbos# set tftp disabled
cbos# write
cbos# reboot

For customers with Cisco 678 routers, there is a choice of CAP or DMT. All customers who connected prior to 1-April-2001 (including simple change of ISP), have to know whether they are CAP or DMT. The 678 can be loaded with either AP or DMT firmware (but you must select one). To find your firmware version, do a "show version" when logged in to the 678.


<for CAP>

cbos# set inter wan0-0 close
cbos# set inter wan0-0 vci 1
cbos# set inter wan0-0 vpi 1
cbos# set inter wan0-0 open

<for DMT>

cbos# set inter wan0-0 close
cbos# set inter wan0-0 vpi 0
cbos# set inter wan0-0 vci 32
cbos# set inter wan0-0 open


Note: For static routers, DHCP service is generally disabled, although there is o reason why the DSL router cannot be a DHCP server. In the configuration above, DHCP is not turned on, which means that it is off by default.

Last Updated on Sunday, 06 July 2008 21:20